If you have been reading about stationary phase and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2026-03-25. Where a claim depends on a specific study, the study is described rather than over-claimed.
Developing an HPLC test begins with defining the analytes, matrix, and required reporting limits. Chemists select a separation mode, column chemistry, mobile phase composition, flow rate, and detection wavelength or mass transition. Experiments then adjust these variables to achieve adequate retention, resolution, and peak shape. System suitability tests confirm that the instrument and method perform consistently before sample analysis. Without suitable resolution, quantitative results may be unreliable. Preliminary runs often use scouting gradients to locate retention windows.
Validation establishes that a method is suitable for its intended purpose. Typical parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantification, robustness, and stability of standards and samples. Acceptance criteria are defined in advance, and results are documented in a validation report. Regulatory guidance for pharmaceuticals, foods, and environmental testing differs, so the applicable framework must be identified. Ongoing verification uses control samples and trend charts after validation. Method transfer to another laboratory may require partial revalidation.
Method validation establishes that an HPLC procedure is suitable for its intended purpose. Typical parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, robustness, and solution stability. Accuracy reflects closeness to a reference value, while precision reflects agreement among repeated measurements. Specificity shows whether the method can measure the analyte without interference from matrix components. Validation is documented through protocols and reports, and the required extent depends on the method's use and regulatory context.
Routine quality control uses system suitability, blank injections, check standards, and control samples to detect drift or contamination. System suitability criteria may specify minimum resolution, maximum tailing factor, and a permitted range for repeated injections. Blank injections reveal carryover or solvent contamination, while check standards confirm calibration accuracy over a batch. Control samples with known analyte levels can show whether results remain within statistical limits. When a control result falls outside limits, the analyst investigates the cause and may invalidate affected results before repeating the batch.
| Property | Value | Notes |
|---|---|---|
| Accuracy | Closeness to true value | Often assessed by recovery of spiked samples |
| Precision | Agreement among repeated measurements | Often reported as relative standard deviation |
| Specificity | Ability to measure analyte without interference | Must separate analyte from impurities and matrix |
| Linearity | Proportional detector response | Evaluated across a defined concentration range |
| Robustness | Resistance to small method changes | Tests flow rate, pH, temperature, and mobile phase composition |
HPLC testing separates dissolved compounds by passing a liquid sample through a column packed with stationary phase. A pump delivers mobile phase at controlled flow, and the sample components interact differently with stationary and mobile phases. Compounds that spend more time in mobile phase elute earlier; those retained by stationary phase elute later. Detectors record elution as peaks, and peak area or height relates to amount. This mechanism underpins quantitative analysis of mixtures.
Most routine HPLC testing uses reversed-phase columns, where the stationary phase is nonpolar and the mobile phase is a polar mixture such as water with an organic solvent. Analytes partition between the two phases according to polarity, size, and charge. Gradients that change solvent composition over time can separate compounds with broad retention ranges. Isocratic conditions keep solvent composition constant and suit simpler mixtures. The choice of column chemistry, pH, and temperature affects selectivity and peak shape.
High-performance liquid chromatography, or HPLC, separates dissolved compounds by passing a liquid mobile phase through a packed column. Components distribute differently between the stationary phase and the moving liquid, so they travel at different speeds and exit at different times. A detector records these eluting bands as peaks, and peak area or height relates to amount. The technique supports testing in pharmaceuticals, foods, environmental samples, and industrial chemicals. Quantification usually depends on calibration with known standards.
Several separation modes exist, including reversed-phase, normal-phase, ion-exchange, size-exclusion, and hydrophilic interaction liquid chromatography. Reversed-phase uses a nonpolar stationary phase with a polar mobile phase and is widely applied to small organic molecules. Gradient elution changes mobile phase composition during the run, while isocratic elution keeps it constant. Column chemistry, particle size, temperature, flow rate, and mobile phase pH all influence retention and resolution. Method development selects conditions that separate analytes from matrix components and from each other.
Carrillo-Briceño et al. (2026) report evidence of exploitation of glyptodonts, ground sloth, proboscideans, macraucheniids and toxodontids by Pleistocene humans from the Taima-Taima site (Venezuela). Eren et al. (2026) provide estimates for the first appearance of the atlatl in western North America on the basis of analysis of the archaeological record, and find no evidence supporting atlatl use by foragers from the Clovis culture. Pettigrew et al. (2026) report evidence from naturalistic experiments indicating that the atlatl was able to deliver fatal wounds to megafauna, including animals as large as mammoths. He et al. (2026) reconstruct the course of peopling of East Asia and subsequent diversification of populations from the studied area during the Paleolithic and Neolithic on the basis of data from Y chromosome genomic data from ancient and modern individuals. Zhang et al. (2026) sequence genomes of individuals from the Donghulin site in the North China Plain, and report evidence of population changes over two millennia during the Paleolithic-Neolithic transition. A partial humerus with morphological affinities with Late Upper Paleolithic modern humans is described from early Holocene strata from Heilongjiang (China) by Wei et al. (2026). Bourgon et al. (2026) report evidence from zinc stable isotope analysis of tooth enamel of humans from the late Pleistocene and Holocene sites from Sri Lanka indicative of a mixed diet including both animal and plant foods, with the plant component of the diet increasing over time (even before the introduction of crop agriculture).
Global Fossil Infrastructure Tracker API – the trade association of the US oil industry. (American Petroleum Institute) U.S. Energy Information Administration U.S. Department of Energy EIA – World supply and consumption Joint Organisations Data Initiative | Oil and Gas Data Transparency U.S. National Library of Medicine: Hazardous Substances Databank – Crude Oil "Petroleum" . The American Cyclopædia. 1879. "A Short History of Petroleum", Scientific American, August 10, 1878, p. 85
=== Transcriptional variants === So far, three different transcription variants (TVs) have been described for CK1δ in humans (Homo sapiens), mice (Mus musculus), and rats (Rattus norvegicus), which are highly homologous. The alignment of all CK1δ sequences of all organisms shows a high homology in the first 399 amino acids, except for position 381. While the human transcription variants are using isoleucine, the mouse and rat sequences incorporate a valine instead. The only exception is rat TV3, which is also transcribing its nucleotide sequence into an isoleucine. After position 399, three different general structures can be observed. The first variant consists of 415 amino acids across all three organisms and is called TV1 in human and rat, while the murine counterpart is named CRAa. The shortest group of sequences consists of 409 amino acids: TV2 in humans and rats, CRAc in mice. The longest variant consists of 428 amino acids in rat (TV3) and mice (CRAb), while the human (TV3) variant is missing the second to last amino acid (threonine), resulting in a protein of a length of 427 amino acids. The various transcription variants are based on a different usage of the exons that are encoding for CSNK1D. The whole gene consists of eleven different exons and is located in humans on chromosome 17 at position 17q25.3. CSNK1D has a length of 35kb and is overlapping with the gene Slc16a3. The intersecting part is exon 11, which is located downstream of exon 10. However, it does not interfere with Slc16a3 since it is located in a non-coding area.
Sources: en.wikipedia.org
Poultices are used on horses to relieve inflammation. Usually applied to the lower legs, under a stable bandage, to focus treatment on the easily injured tendons in the area. Poultices are sometimes applied as a precautionary measure after the horse has worked hard, such as after racing, jumping, or cross-country riding, to forestall strains or stiffness. They may be used to treat abscesses, with the intention of drawing out pus from the wound. Cooling poultices are sometimes used for show-jumpers and racehorses; these may be cheaper and easier to administer than commercial cooling products. A poultice is applied to the horse's distal limbs after exercise, for 9–12 hours. The intended effect is to cool the legs over a long period of time, by dispersing heat from the limb through the action of evaporation. Commonly, the poultice is bandaged over, sometimes with materials such wet newspaper between the poultice and bandages; this greatly reduces evaporation and heat loss, rendering the poultice ineffective at cooling.
== Mutations == Cone dystrophy (COD) is a retinal degradation of photoreceptor function wherein cone function is lost at the onset of the dystrophy but rod function is preserved until almost the end. COD has been linked to several genetic mutations including mutations in the guanylate cyclase activator 1A (GUCA1A) and guanylate cyclase 2D (GUY2D) among other enzymes. To be specific, GUY2D codes for RETGC-1, which is involved in cone adaptation and photoreceptor sensitivity by synthesizing cGMP. Low concentrations of calcium cause the dimerization of RETGC-1 proteins through stimulation from guanylate cyclase-activating proteins (GCAP). This process happens at amino acids 817-857, and mutations in this region increase RETGC-1 affinity for GCAP. This works to alter the calcium sensitivity of the neuron by allowing mutant RETGC-1 to be activated by GCAP at higher calcium levels than the wild-type. Because RETGC-1 produces cGMP, which keeps cyclic nucleotide-gated channels open allowing the influx of calcium, this mutation causes extremely high intracellular calcium levels. Calcium, which plays many roles in the cell and is tightly regulated, disrupts the membrane when it appears in excess. Also, calcium is linked to apoptosis by causing the release of cytochrome c. Therefore, mutations in the RETGC-1 can cause COD by increasing intracellular calcium levels and stimulating cone photoreceptor death.
2 November – Andy Street, the Mayor of the West Midlands, has written to the Home Secretary requesting that his office be granted the powers of the area's Police and Crime Commissioner after the next mayoral election because "crime in this region has more than doubled... and I simply cannot allow it to go on any longer". 5 November – The Metropolitan Police ends its relationship with adviser Attiq Malik after video emerged of him chanting a pro-Palestinian slogan during a speech to a group in 2021. Surrey County Council declares an emergency after thousands of properties are left without water following a technical problem at a Thames Water treatment works, which is attributed to Storm Ciarán. 7 November – Anastrozole, a drug used for a number of years to treat breast cancer, is licensed for use in England as a preventative option. West Yorkshire Police launch a murder investigation after a 15-year-old boy dies following a stabbing near a school in Leeds. He is later named as Alfie Lewis, a former student at Horsforth School. 9 November – A 14-year-old boy is remanded in custody charged with the murder of Alfie Lewis. Labour's Caroline Woodley is elected mayor of Hackney in London in a by-election. 10 November – Following trial and conviction at Leicester Crown Court, Katie Tidmarsh is sentenced to life imprisonment with a minimum term of 17 years for the 2012 murder of Ruby Thompson, a one-year-old child she had hoped to adopt.
Sources: en.wikipedia.org
System suitability is a set of checks performed before and during a run to confirm that the instrument, column, and method work as expected. Common checks include resolution, tailing factor, theoretical plates, and relative standard deviation of replicate injections. Failure triggers troubleshooting or method adjustment.
Validation demonstrates that a method produces reliable results for a defined purpose. It documents performance limits and acceptance criteria. Regulated industries require validation before routine testing of products or samples.
Retention time shifts can arise from changes in mobile phase composition, pH, temperature, column age, or flow rate. Contamination or worn seals may also alter pressure and delivery. Systematic checks of these factors help identify the cause.
Validation establishes suitability for a new method, while verification confirms that a method works in a specific laboratory. Verification is often used when a validated method is adopted with existing equipment and staff. Both rely on documented acceptance criteria.