stationary phase is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Last reviewed on 2026-04-10. Where a claim depends on a specific study, the study is described rather than over-claimed.
HPLC testing separates dissolved compounds by passing a liquid sample through a column packed with stationary phase. A pump delivers mobile phase at controlled flow, and the sample components interact differently with stationary and mobile phases. Compounds that spend more time in mobile phase elute earlier; those retained by stationary phase elute later. Detectors record elution as peaks, and peak area or height relates to amount. This mechanism underpins quantitative analysis of mixtures.
Most routine HPLC testing uses reversed-phase columns, where the stationary phase is nonpolar and the mobile phase is a polar mixture such as water with an organic solvent. Analytes partition between the two phases according to polarity, size, and charge. Gradients that change solvent composition over time can separate compounds with broad retention ranges. Isocratic conditions keep solvent composition constant and suit simpler mixtures. The choice of column chemistry, pH, and temperature affects selectivity and peak shape.
Developing an HPLC test begins with defining the analytes, matrix, and required reporting limits. Chemists select a separation mode, column chemistry, mobile phase composition, flow rate, and detection wavelength or mass transition. Experiments then adjust these variables to achieve adequate retention, resolution, and peak shape. System suitability tests confirm that the instrument and method perform consistently before sample analysis. Without suitable resolution, quantitative results may be unreliable. Preliminary runs often use scouting gradients to locate retention windows.
Validation establishes that a method is suitable for its intended purpose. Typical parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantification, robustness, and stability of standards and samples. Acceptance criteria are defined in advance, and results are documented in a validation report. Regulatory guidance for pharmaceuticals, foods, and environmental testing differs, so the applicable framework must be identified. Ongoing verification uses control samples and trend charts after validation. Method transfer to another laboratory may require partial revalidation.
| Property | Value | Notes |
|---|---|---|
| Separation mode | Reversed-phase | Nonpolar stationary phase with polar mobile phase |
| Typical column particle size | 3–5 µm | Smaller particles improve resolution but raise pressure |
| Typical flow rate | 0.5–2.0 mL/min | Depends on column dimensions and pressure limits |
| Common detection | UV-Vis absorbance | Requires analytes with chromophores |
| Typical run time | 5–30 min | Varies with method, gradient, and sample complexity |
High-performance liquid chromatography, or HPLC, separates dissolved compounds by passing a liquid mobile phase through a packed column. Components distribute differently between the stationary phase and the moving liquid, so they travel at different speeds and exit at different times. A detector records these eluting bands as peaks, and peak area or height relates to amount. The technique supports testing in pharmaceuticals, foods, environmental samples, and industrial chemicals. Quantification usually depends on calibration with known standards.
Several separation modes exist, including reversed-phase, normal-phase, ion-exchange, size-exclusion, and hydrophilic interaction liquid chromatography. Reversed-phase uses a nonpolar stationary phase with a polar mobile phase and is widely applied to small organic molecules. Gradient elution changes mobile phase composition during the run, while isocratic elution keeps it constant. Column chemistry, particle size, temperature, flow rate, and mobile phase pH all influence retention and resolution. Method development selects conditions that separate analytes from matrix components and from each other.
Routine quality control uses system suitability, blank injections, check standards, and control samples to detect drift or contamination. System suitability criteria may specify minimum resolution, maximum tailing factor, and a permitted range for repeated injections. Blank injections reveal carryover or solvent contamination, while check standards confirm calibration accuracy over a batch. Control samples with known analyte levels can show whether results remain within statistical limits. When a control result falls outside limits, the analyst investigates the cause and may invalidate affected results before repeating the batch.
Documentation and traceability are central to regulated HPLC testing. Records typically include instrument logs, column history, mobile-phase preparation, sample preparation, injection sequences, raw chromatograms, and audit trails. Electronic systems may require user access controls, time-stamped changes, and backup procedures. Training records show that analysts are qualified for assigned methods. Audits and inspections check whether written procedures match actual practice and whether deviations are documented. These controls support reproducibility and allow results to be reconstructed if questions arise later.
=== North America === The mummies of North America are often steeped in controversy, as many of these bodies have been linked to still-existing native cultures. While the mummies provide a wealth of historically significant data, native cultures and tradition often demands the remains be returned to their original resting places. This has led to many legal actions by Native American councils, leading to most museums keeping mummified remains out of the public eye.
Metabolic syndrome is a clustering of at least three of the following five medical conditions: abdominal obesity, high blood pressure, high blood sugar, high serum triglycerides, and low serum high-density lipoprotein (HDL). Metabolic syndrome is associated with the risk of developing cardiovascular disease and type 2 diabetes. In the U.S., about 25% of the adult population has metabolic syndrome, a proportion increasing with age, particularly among racial and ethnic minorities. Insulin resistance, metabolic syndrome, and prediabetes are closely related to one another and have overlapping aspects. The syndrome is thought to be caused by an underlying disorder of energy utilization and storage, but the cause of the syndrome is an area of ongoing medical research. Researchers debate whether a diagnosis of metabolic syndrome implies differential treatment or increases risk of cardiovascular disease beyond what is suggested by the sum of its individual components.
== Notes == a "Points" refers to carry-over points accrued following the sanction. For example, 154.69 points draw a one-match suspension, with 54.69 carry-over points (for every 100 points, a one-match suspension is given). s Denotes amount of seasons on the Essendon list only.
Sources: en.wikipedia.org
is the mass generation rate of the substance - assumed to be a constant, i.e. not a function of time (equal to zero for exogenous (foreign) substances/drugs) [mmol/min] or [mol/s] t is dialysis time or time since injection of the substance/drug [min] or [s] V is the volume of distribution or total body water [L] or [m3] K is the clearance [mL/min] or [m3/s] C is the concentration [mmol/L] or [mol/m3] (in the United States often [mg/mL]) From the above definitions it follows that
=== Race and ethnicity === Given that the research for BED is not supported on the topic of ethnicity, it makes it difficult to understand how common BED is. However, the racial makeup of BED distinctly varies from anorexia nervosa and bulimia nervosa. BED has the same effect no matter the color of someone's skin. Many studies surround BED being focused on white women. One literature review found information citing no difference between BED prevalence among Hispanic, African American, and White women while other information found that BED prevalence was highest among Hispanics followed by Black individuals and finally White people. A 2021 study has observed "higher rates of BED as compared to other ethnic groups" for African Americans. The likelihood of reporting eating disorder symptoms is also lower in some groups, including African Americans. Asian-Americans also face decreased reporting of ED symptoms. This can be partly attributed to "significantly higher thin-ideal internalization" compared to other ethnic groups. Migration can also influence BED risk. Mexican-American immigrants have been observed to face a greater risk of BED following migration.
With the exception of dual flow (see below) CCC, most countercurrent chromatography modes of operation have a stationary phase and a mobile phase. Even in this situation, countercurrent flows occur within the instrument column. Several researchers have proposed renaming both CCC & CPC to liquid-liquid chromatography, but others feel the term "countercurrent" itself is a misnomer. Unlike column chromatography and HPLC, countercurrent chromatography operators can inject large volumes relative to column volume. Typically 5 to 10% of coil volume can be injected. In some cases this can be increased to as high as 15 to 20% of the coil volume. Typically, most modern commercial CCC and CPC can inject 5 to 40 g/L capacity. The range is so large, even for a specific instrument, let alone all instrument options, as the type of target, matrix and available biphasic solvent vary so much. Approximately 10 g/L would be a more typical value, that the majority of applications could use as a base value. The countercurrent separation starts with choosing an appropriate biphasic solvent system for the desired separation. A wide array of biphasic solvent mixtures are available to the CCC practitioner including the combination n-hexane (or heptane), ethyl acetate, methanol and water in different proportions. This basic solvent system is sometimes referred to as the HEMWat solvent system. The choice of solvent system may be guided by perusal of the CCC literature. The familiar technique of thin layer chromatography may also be employed to determine an optimal solvent system.
Sources: en.wikipedia.org
== Multi-junction == The increased demand for faster and easy-to-use protein separation tools has accelerated the evolution of IEF towards in-solution separations. In this context, a multi-junction IEF system was developed to perform fast and gel-free IEF separations. The multi-junction IEF system utilizes a series of vessels with a capillary passing through each vessel. Part of the capillary in each vessel is replaced by a semipermeable membrane. The vessels contain buffer solutions with different pH values, so that a pH gradient is effectively established inside the capillary. The buffer solution in each vessel has an electrical contact with a voltage divider connected to a high-voltage power supply, which establishes an electrical field along the capillary. When a sample (a mixture of peptides or proteins) is injected in the capillary, the presence of the electrical field and the pH gradient separates these molecules according to their isoelectric points. The multi-junction IEF system has been used to separate tryptic peptide mixtures for two-dimensional proteomics and blood plasma proteins from Alzheimer's disease patients for biomarker discovery.
=== Metabolic and covalent labeling of glycans === Metabolic labeling of glycans can be used as a way to detect glycan structures. A well known strategy involves the use of azide-labeled sugars which can be reacted using the Staudinger ligation. This method has been used for in vitro and in vivo imaging of glycans.
===== Kidnapping of Jesús Alfredo Guzmán Salazar and Iván Archivaldo Guzmán ===== In August 2016 in an upmarket restaurant called La Leche in the resort city of Puerto Vallarta, the CJNG kidnapped two sons of Joaquin Guzmán Loera (El Chapo), Jesús Alfredo Guzmán Salazar and Iván Archivaldo Guzmán Salazar, along with friends and then released them after negotiations. The event happened shortly after the incarceration of Joaquín Guzmán and was seen as a humiliation for the powerful Sinaloa cartel.
Certificate of Merit (1987) from the Indian Chemical Society for the best paper presentation, at the Convention of Chemists, 1987 2. Special Award and Citation (1988) of the Syndicate of Calicut University, Kerala, India for outstanding research contributions during 1985-1988 3. Swarnajayanti Research Grant (2001), Special research grant to outstanding young researchers by DST, Govt. India 4. Ramanna Fellow, DST (2007) 5. Adjunct Professor, Material Science Programme, IIT, Kanpur 6. Dean, Chemical Sciences, Academy of Scientific and Innovative Research (AcSIR) 7. A. V. Rama Rao Foundation Award Lecture of JNCASR, Bangalore (2012) 8. R. A. Mashelkar Endowment, NCL Pune (2012) 9. Chair on Nanoscience and Nanotechnology, Centre for Nanoscience and Nanotechnology, Mahatma Gandhi University, Kottayam, Kerala, 2013 10. Prof. K. K. M. Yusuff Endowment, Cochin University of Science and Technology, 2013 11. CHEMCON distinguished speaker award, 2016. 12. ISCB-2017 Award given by Indian Society of Chemists and Biologists. Academy Fellowships 1. Fellow, Indian Academy of Sciences, Bangalore (2006) 2. Fellow, National Academy of Sciences, Allahabad, India (2011) 3. Fellow, Indian National Science Academy, New Delhi (2012) 4. Honorary Fellow, Kerala Academy of Sciences (2013) 5. Fellow, Royal Society of Chemistry, London (2014) 6. Fellow, The World Academy of Science (2015) Research Fellowships
Sources: en.wikipedia.org
It separates components in a liquid sample and measures their amounts using a detector. Results can indicate concentration, purity, or identity based on retention time and detector response. The technique works for mixtures that can be dissolved and filtered.
It offers high resolution, reproducibility, and compatibility with many sample types. A single run can separate and quantify multiple analytes. It is common in pharmaceutical, food, environmental, and industrial laboratories.
Samples must be soluble in a suitable mobile phase and free of particles that can block the column. Detector response depends on analyte structure, so some compounds need derivatization or alternative detection. Complex matrices may require extensive sample preparation.
System suitability is a set of checks performed before and during a run to confirm that the instrument, column, and method work as expected. Common checks include resolution, tailing factor, theoretical plates, and relative standard deviation of replicate injections. Failure triggers troubleshooting or method adjustment.